| CHECK INPUT SIGNAL FOR TCM USING SUBARU SELECT MONITOR. |
|
1) Connect the connectors to TCM and transmission. 2) Connect the Subaru Select Monitor to the data link connector. 3) Turn the ignition switch to ON. 4) Run the Subaru Select Monitor. 5) Start the engine. 6) Move the select lever to the “P” or “N” range. 7) Read the data of “Turbine Revolution Speed” using Subaru Select Monitor. 8) Compare the tachometer with Subaru Select Monitor indications. |
| QUESTION | |
|
Is the revolution value same as the tachometer reading shown on the combination meter? | |
| Yes | No |
|
Check for poor contact in the TCM and transmission harness or connectors, and repair the fault location. |
|
