| CHECK HARNESS BETWEEN ECM AND CAMSHAFT POSITION SENSOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connectors from the ECM and camshaft position sensor. 3) Measure the resistance of harness between the ECM and camshaft position sensor connector. Connector & terminal (B134) No. 12 — (E15) No. 1: (B134) No. 22 — (E15) No. 2: |
| QUESTION | |
|
Is the resistance less than 1 Ω? | |
| Yes | No |
|
|
Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit of the harness between the ECM and camshaft position sensor • Poor contact of coupling connector |
