CHECK CURRENT DATA.

1) Start the engine.

2) Read the data of tumble generator valve position sensor signal (RH) using Subaru Select Monitor or general scan tool.

NOTE:

• Subaru Select Monitor

For detailed operation procedures, refer to “READ CURRENT DATA FOR ENGINE”.

• General scan tool

For detailed operation procedures, refer to the general scan tool operation manual.

QUESTION
Is the voltage less than 0.2 V?
Yes	No
	Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the fault condition, and reperform the check. NOTE: In this case, there may be a temporary connector contact failure.