CHECK MASS AIR FLOW AND INTAKE AIR TEMPERATURE SENSOR.

1) Start the engine and warm up engine until coolant temperature is higher than 75°C (167°F).

2) For AT models, set the select lever to “P” range or “N” range, and for MT models, place the shift lever in the neutral position.

3) Turn the A/C switch to OFF.

4) Turn all the accessory switches to OFF.

5) Read the data of mass air flow and intake air temperature sensor signal using Subaru Select Monitor or general scan tool.

NOTE:

• Subaru Select Monitor

For detailed operation procedures, refer to “READ CURRENT DATA FOR ENGINE”.

• General scan tool

For detailed operation procedures, refer to the general scan tool operation manual.

QUESTION
Is the measured value 1.5 — 4.0 g/s (0.20 — 0.53 lb/m) (1.5 L model), or 2.0 — 5.0 g/s (0.26 — 0.66 lb/m) (2.0 L model)?
Yes	No
	Replace the mass air flow and intake air temperature sensor.