| CHECK HARNESS BETWEEN ECM AND ACCELERATOR PEDAL POSITION SENSOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connector from the ECM and accelerator pedal position sensor. 3) Measure the resistance of harness between ECM and accelerator pedal position sensor connector. Connector & terminal (B135) No. 31 — (B315) No. 3: (B135) No. 22 — (B315) No. 2: |
| QUESTION | |
|
Is the resistance less than 1 Ω? | |
| Yes | No |
|
|
Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit of harness between the ECM and accelerator pedal position sensor connector. • Poor contact of joint connector |
