| CHECK HARNESS BETWEEN ECM AND STARTER RELAY CONNECTOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connectors from the ECM. 3) Measure the resistance of harness between ECM and starter relay connector. Connector & terminal LHD model (B135) No. 32 — (B225) No. 12: RHD model (B135) No. 32 — (B225) No. 23: |
| QUESTION | |
|
Is the resistance less than 1 Ω? | |
| Yes | No |
|
|
Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit of harness between ECM and starter relay connector • Poor contact of joint connector (RHD model) • Poor contact of joint connector (RHD model) |
