| CHECK HARNESS BETWEEN COMBINATION METER AND IGNITION SWITCH CONNECTOR. |
|
1) Turn the ignition switch to ON. 2) Measure the voltage between combination meter connector and chassis ground. Connector & terminal (i10) No. 2 (+) — Chassis ground (−): |
| QUESTION | |
|
Is the voltage 10 V or more? | |
| Yes | No |
|
Replace the combination meter circuit board. |
Check the following item and repair or replace if necessary. NOTE: • Blown out of fuse (No. 5) • Open or short circuit in harness between fuse (No. 5) and battery terminal • Poor contact of ignition switch connector |
