| CHECK HARNESS BETWEEN ECM AND DELIVERY (TEST) MODE CONNECTOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connectors from the ECM. 3) Measure the resistance of harness between delivery (test) mode connector and ECM. Connector & terminal (B76) No. 1 — (B135) No. 3: (B76) No. 1 — (B135) No. 4: (B75) No. 1 — (B136) No. 35: |
| QUESTION | |
|
Is the resistance less than 1 Ω? | |
| Yes | No |
|
|
Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit of harness between ECM and delivery (test) mode connector • Poor contact of joint connector |
