| CHECK POWER SUPPLY OF CAMSHAFT POSITION SENSOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connector from camshaft position sensor. 3) Turn the ignition switch to ON. 4) Measure the voltage between camshaft position sensor connector and engine ground. Connector & terminal (E15) No. 1 (+) — Engine ground (−): |
| QUESTION | |
|
Is the voltage 10 V or more? | |
| Yes | No |
|
|
Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit in harness between main relay connector and camshaft position sensor connector • Poor contact of coupling connector |
